dd-wrt client bridge DLNA problem - Wireless

Best settings to use | MyOpenRouter I just tried the Shibby's tomato for a few days, overall the router's signal is much stronger. So I guess default signal power setting with dd-wrt is higher than tomato. So I flashed back to dd-wrt. Here is my settings, at least it is working. All AC devices tied to 5G1, N to 5G. dd-wrt client bridge DLNA problem - Wireless Nov 12, 2013 HOWTO: DD-WRT Client Bridged Mode - SpeedGuide Jul 09, 2007

openWrt and velops in bridged mode: guest wifi cli

Jul 09, 2007 openWrt and velops in bridged mode: guest wifi cli hello, i tried to put a openwrt router between modem and velops in bridge mode. openwrt router has no wifi. velop creates a main wifi and a guest wifi (if i connect my phone to the main wifi, it has an ip 192.168.1.113, switch to guest wifi, 192.168.3.113) turns out in openwrt's active dhcp table,

Jul 04, 2020

Also note that on newer hardware and dd-wrt versions, e.g. MIMO radios, Client Bridge may not exist in the list of wireless modes. In this case, use Repeater Bridge - which provides a bridge to both wired clients and another AP extended for more potential wireless clients, all of which will be bridged through the Repeater Bridge device. Bridging - DD-WRT Wiki The DD-WRT router creates a subnet LAN. The subnet LAN has clients connected to it with cable connections. (On the firmware page, the menu choice for this mode simply reads “Client”.) Client Bridge. See Client_Bridged. The previous page remains for reference Wireless_Bridge Broadcom WiFi DD-WRT Client Bridge Setup - YouTube